Setup and Configure HP Wireless E-MSM720 Wireless Controller with HP E-MSM430 Access Points
KB ID 0000692 Problem We got some ‘demo stock’ in the office this week, I don’t do a lot of wireless, so I thought I would get it setup and have a look to see how easy/difficult it was. Hardware used HP E-MSM720 Premium Mobility Controller (J9694A) HP E-MSM 430 Wireless N Dual Radio Access Point (J9651A) HP HP 2915-8G-P-o-E Switch (J5692A) The switch and controller are ‘tiny’ so if you want to put them...
Manually Configuring HP Wireless (MSM 720 controller) for Public and Private Wireless Networks
KB ID 0000833 Problem In the following procedure I’ll configure the following; HP 5412zl Switch. Cisco ASA 5510 Firewall. HP MSM720 Controller. HP MSM460 and MSM317 Access Points. If you are configuring an MSM765zl or MSM775zl use the following article first. HP MSM765zl and 775zl – Initial Setup and Routing Assumptions Private SSID will be on the normal corporate LAN (In this case 172.16.254.0/24). Public SSID will get...
Register HP Wireless Access Points With an HP MSM Controller on a Different Subnet
KB ID 0000913 Problem If you have HP Access Points on remote sites, you have the choice of either leaving them in automomous mode, or registering them with a controller at another site. This is handy if you want to manage all your VSC’s from one location. You can do this via DNS, or via DHCP at that remote site, (I tend to setup both to be on the safe side). Solution Option 1: Set MSM Controller Location via DHCP 1. On your...
Setup an HP 1800-24G (J9028B) Switch
KB ID 0000800 Problem Essentially you can unbox this switch, plug it in and it will do what you want (unless you have VLANS, or trunks (port-channels)). Which is what my client had done, but I needed to get on the web console and have a look at what was going on, and there is NO CONSOLE socket on this unit at all. Solution 1. Don’t bother looking in DHCP, it’s NOT set to DHCP by default. From the factory the switch will have...
Outlook Error 0x800CCC0F – Using POP3 To Exchange – Behind a Cisco CSC (Trend InterScan) Module
KB ID 0000642 Problem I upgraded a clients firewall and CSC software a couple of weeks ago, and ever since “some” users saw the following errors, Error 0x800CCC0F Task ‘{email address} – Sending’ reports error (0x800CCC0F): #The connection to the server was interrupted. If the problem continues, contact your server administrator or Internet service provider (ISP).’ Eventually it would time out...