WAIK (Windows 7) Installing the Supplement for Windows 7 SP1
KB ID 0000450 Problem I’ve been doing some prep work with WDS this week for a client, (I’ve covered Deploying Windows 7 with WDS before). So I went to check if there was a new WAIK as Windows 7 and Server 2008 R2 have had a Service Pack 1 released since last time I deployed windows 7 in bulk. And sure enough, there is an update. (Though the update is for WindowsPE Not the SIM tools I would be using). The Windows®...
VMware ESX – WDS Fails “The network location cannot be reached”
KB ID 0000308 Problem Whilst trying to contact a WDS server from an ESX client machine (though this can happen on a physical machine also). You see the following error, The network location cannot be reached, For information about network troubleshooting, se Windows Help. Solution This is because the WindowsPE image you are using to Capture/Deploy does not have the network drivers for the NIC in the machine you are imaging (At...
WDS Deploying Windows Part 2: Prepare Windows, and Capture to WDS
KB ID 0000737 Problem In part one we built and configured the WDS Server. Now you need to prepare the reference Windows 8 machine so that you can ‘capture’ its image. Solution Before you start, make sure that the machine you are imaging has PLENTY of room on one of its local drive(s), because it copies the image locally, before it sends it to WDS. Place Your Reference Windows 8 Machine in Audit Mode To put all the software...
Windows Deployment Services (On Server 2008 R2) Deploying Windows 7
KB ID 0000180 Problem It’s been a while since I posted run through’s on WDS – they were on Server 2003, and were for deploying Windows XP. I’ve completely re-written this page and shot a series of videos to make the process a little easier to understand. Solution Step 1 Notes 1. If the WDS Server is NOT the DHCP server then do NOT tick both the DHCP options, (as stated in the video), on your DHCP scope...
Adding / Injecting Drivers into WindowsPE
KB ID 0000218 Problem A while ago I wrote an article about adding drivers to a WindowsPE Image, this was part of an installing Symantec Ghost with WDS procedure. Recently one of my colleagues was using my instructions, and despite his best efforts could not get the procedure to work with a new PC (Intel NIC). So he decided to give it a go with the new version of the WAIK he was successfull, but the procedure is slightly different....