HP MSM 765zl – How To Factory Reset
KB ID 0000916 Problem I had to setup some HP wireless gear again this week. It had been installed a while ago, but not used and there was some problems with it, so I elected to flatten it and start again. The handbook goes through how to factory reset it from the web management interface. That’s great if you can get to the management console, but I could not. Solution As the MSM765zl is a controller that is on a...
HP MSM765zl and 775zl – Initial Setup and Routing
KB ID 0000917 Problem The MSM 765zl and 775zl, unlike the rest of the HP MSM controller series, do not have any physical Ethernet ports on them. So before you can get to its web management interface, you need to be able to give it an IP address, and then the controller needs to be able to find a route back to where you are, assuming you are not on a flat unrouted/single VLAN. Obviously if you are directly connected to the same...
Install and Configure an HP UPS Network Module
KB ID 0000813 Problem I installed one of these a couple of weeks ago, and there’s some good documentation with the module itself so installing it into the UPS and giving it an IP address was easy, getting the right client software to talk to it was a pain. Solution Configure the Network Module 1. Physically install the module in the UPS, it’s fixed with two screws and you can install it with the UPS powered on. 2. It takes a...
HP Networking ‘ProCurve’ – Trunking / Aggregating Ports
KB ID 0000638 Problem I was lending a hand this week, while my colleague swapped out a lot of switches. I don’t usually deploy a large number of HP switches, so I was surprised when we installed a chassis switch and after patching the fiber links, the Cisco Catalyst switches all got upset and we lost three out of four ping packets. I (wrongly) assumed that STP would be enabled, so I wandered back and pulled the second fiber...
HP 1810-8G Switch – Setup and Management
KB ID 0000732 Problem For such a ‘baby’ switch this has a LOT of features, I had to lock down the speed and duplex settings on one of the switch ports today. The main details you will be looking for are, Default IP address = 192.168.2.10 Default Password = blank Solution 1. Put yourself on the same network: Windows Key+R > ncpa.cpl {enter} > Right click your network connection > Properties > Internet...