Cisco ISE – Upgrading
KB ID 0001071 Problem Just as I was hunting around for an NFR version of Cisco ISE 1.3, they released 1.4. I wasn’t sure if I could upgrade my NFR version without breaking it so I thought I would ‘have a go’. Solution If you read the documentation for the upgrade of 1.2 to 1.4, I suggest you skip straight to the tasks to do AFTER upgrade, as it has a habit of resetting things back to default, best to make sure you...
Cisco Firewall (ASA/PIX) – Granting Access to an FTP Server
KB ID 0000772 Problem If you have an FTP server, simply allowing the FTP traffic to it wont work. FTP (in both active and passive mode) uses some random high ports that would normally be blocked on the firewall. So by actively inspecting FTP the firewall will know what ports to open and close. Solution How you ‘allow’ access to the FTP server will depend on weather you have a public IP address spare or not, if you only...
ASA 5585-X Update the CX SSP Module
KB ID 0001005 Problem Every piece of documentation I found on upgrading CX SSP modules was for doing so on models other than the ASA5585-X. The (current) latest CLI guide says; “For the ASA 5585-X hardware module, you must install or upgrade your image from within the ASA CX module. See the ASA CX module documentation for more information.” Yeah good luck finding that! Solution Before I saw the information above I tried...
ASA Upgrading and Imaging a Hardware CX Module
KB ID 0001025 Problem Last time I had to do one of these the process was very straight forward, one command and the ASA got its new image from FTP, extracted it, and then installed it. I had a CX module fail last week, and Cisco shipped me out a replacement. After installing it and running the setup, I needed to upgrade it (it will be managed by PRSM). It was running version 9.0.2 (probably been on the shelf a while!). And every time...
Dreamweaver CS6 – Backup and Restore Site Settings
KB ID 0000672 Problem If you are like me and struggle to remember settings, passwords etc. Then being able to back up all your website settings in Dreamweaver so you can restore them back again, (after a rebuild on a new PC) can save you some heartache. Solution 1. On the SOURCE machine, Launch Dreamweaver > Site > Manage Sites > Select the site in question > Select the ‘Export Site’ Icon. 2. Choose whether to...