Manually Configuring HP Wireless (MSM 720 controller) for Public and Private Wireless Networks
KB ID 0000833 Problem In the following procedure I’ll configure the following; HP 5412zl Switch. Cisco ASA 5510 Firewall. HP MSM720 Controller. HP MSM460 and MSM317 Access Points. If you are configuring an MSM765zl or MSM775zl use the following article first. HP MSM765zl and 775zl – Initial Setup and Routing Assumptions Private SSID will be on the normal corporate LAN (In this case 172.16.254.0/24). Public SSID will get...
Install and Configure an HP UPS Network Module
KB ID 0000813 Problem I installed one of these a couple of weeks ago, and there’s some good documentation with the module itself so installing it into the UPS and giving it an IP address was easy, getting the right client software to talk to it was a pain. Solution Configure the Network Module 1. Physically install the module in the UPS, it’s fixed with two screws and you can install it with the UPS powered on. 2. It takes a...
Cisco Catalyst Switches – Set a Management IP and Allow Telnet and Web Management
KB ID 0000614 Problem If you want to manage your Cisco Catalyst switch it’s not always practical to plug a console cable in to change its settings or monitor what it is doing. Putting an IP address on it and enabling remote management via Telnet or from your web browser is a better alternative, particularly if you have a lot of switches. Solution Enable Telnet Management on Cisco Catalyst Switch 1. Connect to the Switch using a...
Connecting to and Configuring Cisco Routers with ‘Cisco Configuration Professional’
KB ID 0000512 Problem It’s not often I work on Cisco routers, but as I tend to do most of the Cisco ASA Firewalls, I’m the unofficial “Cisco Guy”. Which is fine until someone wants a router or some complex switching, then I need to do some heavy duty frowning. Last time I put in a Cisco router it was a baby Cisco 800 series (an 877W) so I assumed the 1921 ISR router I had to put in would be the same. Before I...
Cisco Router IOS – Configuring EIGRP
KB ID 0000929 Problem For the first time in about ten years I had to deal with EIGRP last week, so I thought I would run it up in a lab. Normally I would use GNS3 but for this procedure I’ll use Cisco Packet Tracer.</p< In fact I’ll include the files so you can download and use the lab yourself, (if you have a copy of Packet Tracer). And I’ll also include the configs for all the routers. In the lab I’ve...