Backup Exec Job Fails With an E000FE30 Error
Nov17

Backup Exec Job Fails With an E000FE30 Error

KB ID 0000382  Problem A common error on Backup Exec version 12, essentially the media server is losing communication to the Backup Exec remote agent Note: Even if you only have one server it will still be running a remote agent! Errors: Final error: 0xe000fe30 – A communication failure has occurred Final error category: Server Errors V-79-57344-65072 – The Exchange Store service is not responding. Backup set canceled....

Read More
Backup Exec Error – ” The backup-to-disk folder that was specified for this job must be on a local NTFS volume”
Nov17

Backup Exec Error – ” The backup-to-disk folder that was specified for this job must be on a local NTFS volume”

KB ID 0000574  Problem I got this when backing up to an HP RDX removable disk backup system. The drive WAS formatted as NTFS, but the job failed with the following error; Error: V-79-57344-4608 – 0xe0001200 – This operation requires a backup-to-disk folder on a local NTFS volume on the media server. Check the job log for details V-79-57344-4608 – The backup-to-disk folder that was specified for this job must be on a...

Read More
Backup Exec – Using RDX Drives
Nov17

Backup Exec – Using RDX Drives

KB ID 0000578 Problem While I like RDX drives, (they have advantages over magnetic tape), but they do have a drawback, throughput. As you can see the removable drive/cartridges are just 1TB SATA Drives in a protective jacket, with a “write protection switch” on them. So they should be perfect as a backup medium, the problem is, the drive carrier itself runs off the USB bus, so they can’t run faster than 48MB a second...

Read More
Symantec Backup Exec 2012 – Restore Option ‘Greyed Out’
Nov17

Symantec Backup Exec 2012 – Restore Option ‘Greyed Out’

KB ID 0000721  Problem Seen when trying to carry out a restore in Bexec 2012, when you select the server you wish to restore, (on the Backup and restore tab), both the restore icon, and restore on the right click menu, are greyed out and cannot be selected. Solution 1. Double click the server in question to open its properties. Select the job history tab and locate either the last good backup, or the backup you wish to restore from....

Read More
Backup Exec Job Failed Error ‘A device attached to the system is not functioning’
Nov17

Backup Exec Job Failed Error ‘A device attached to the system is not functioning’

KB ID 0000871  Problem I Replaced a tape drive for a customer a couple of weeks ago. With the new one fitted I backed up a few files and restored them to make sure the new drive was OK, and checked the backups the following morning. They had failed with the following on the job log. (Click for larger image). Job ended: xxxxxxxxxxxxxxxx Completed status: Failed Final error: 0xe00084f4 – An unknown error has occurred. Final error...

Read More
Cannot Delete ARCServe  Job
Nov17

Cannot Delete ARCServe Job

KB ID 0000018  Problem Backup job listed as <corrupted> and cannot be deleted, this is caused by ARCServe crashing or a power cut while the job was being worked on. Solution 1. Start > run > cmd {enter} 2. cd c:program filescaBrightstor Arcserve Backup {enter} 3. cstop {enter} 4. Start > Run > %BAB_HOME% {enter} 5. Rename the folder 00000001.qsd to OLD_00000001.qsd 6. Switch back to the command Window 7. cstart...

Read More