Cisco PIX 500 – IPSEC Site to Site VPNs (v6)
KB ID 0000611 Problem Note: This is for firewalls running an operating system BEFORE version 7, if you have an PIX running version 7 or above go here instead. I’ll run though he commands first and then the configuration from PDM at the end. Solution PIX 500: Configure a site to site VPN from command line 1. Connect to the PIX, go to “enable mode”, then to “Configure terminal mode” User Access...
Cisco ASA to Juniper SRX Site to Site VPN
KB ID 0000710 Problem You want to establish a site to site VPN from a site with a Cisco ASA firewall, to another site running a Juniper SRX firewall. I had to do this this week, and struggled to find any good information to help. In the example below I’m configuring the whole thing from a laptop (172.16.254.206) that’s on the Juniper’s site. Use the diagram below, and substitute your own IP addresses and subnet...