Windows – Backing up, Transferring, and Restoring Wireless Network Settings
KB ID 0000626 Problem If you have a machine setup and working on your wireless network, sometimes it’s easier to set other machines up by simply migrating the settings. Either because you don’t want your child to try and type in a 64 bit WPA key, or you might simply have forgotten the WEP/WPA key,and don’t want to go through all the hassle of setting it up again. In a small business environment you can give your...
Installing Windows From USB
KB ID 0000191 Problem This weekend I needed to install Windows 7 on my shiny new Acer HTPC, but having no internal CD/DVD drive I needed to do this via USB. Quite a few times now I’ve needed to install Windows (Particularly Server 2008), on a machine that has no DVD Drive. You can now install both products from a bootable USB drive by doing either of the the following. Note: You will need a USB Drive with enough free space on it...
Windows – USB to Serial Port Converter Drivers
KB ID 0000211 Problem You don’t have a serial port on your laptop so to console into some network equipment you need a USB/Serial Adaptor, I did have some hassle getting drivers for my old Vista Laptop but thankfully I found these ones. {vista-prolific-chip-driver-for-serial-adapters 1.8Mb} But they wouldn’t load on Windows 7. Solution 1. Run the same drivers above, but in compatibility mode for Vista. Right Click the...
HP StorageWorks P2000 – Connecting to and Configuring
KB ID 0000569 Problem Normally I simply connect a new MSA to a clients network, and it gets it’s address from DHCP. Then I can get the address for the DHCP Scope, and point my web browser at it. Yesterday I was starting with new virtual infrastructure and had no DHCP. With the G1 and G2 models, you got a console/serial cable and could just terminal in. With the G3 they have replaced the serial socket with a mini USB socket....
Boot from USB Drive fails with “Cannot get bank X parameters” error
KB ID 0000501 Problem Seen on an HP ML115 while booting to a USB Drive (a SanDisk Cruzer Blade 4GB drive). Error: Cannot get bank 2 parameters. Warning: Bank 2 partition type invalid. Ignoring. Panic: No usable banks found. Solution 1. Reboot the server and enter the BIOS. 2. Locate the USB Mass Storage Device Configuration > USB Settings and change the emulation from [Auto] to [Hard Disk]. 3. Be aware if you have other hard...