Cisco PIX 500 – IPSEC Site to Site VPNs (v6)
KB ID 0000611 Problem Note: This is for firewalls running an operating system BEFORE version 7, if you have an PIX running version 7 or above go here instead. I’ll run though he commands first and then the configuration from PDM at the end. Solution PIX 500: Configure a site to site VPN from command line 1. Connect to the PIX, go to “enable mode”, then to “Configure terminal mode” User Access...
Cisco AnyConnect – PAT External VPN Pool To An Inside Address
KB ID 0001104 Problem I got sent to Holland this week to look at a firewall deployment, and while I was sat in the Airport, I was going over the job I had to do, when I realised the solution I had suggested had a problem see below; My brief was to provide remote AnyConnect VPN into the network so the client could get their network setup, and manage things remotely. However as I drew the network out in my head I realised that the...