Forcing Azure AD Connect Sync
Aug29

Forcing Azure AD Connect Sync

KB ID 0001590 Problem If you are using Azure AD Connect, (AAD Connect) to sync your on-premise Active Directory with Azure AD (i.e. for Office 365), then there may be times when you need to manually ‘force a replication’ because by default it’s going to take 30 minutes between each normal ‘delta replication’ Solution If you are directly on the server that’s running Azure AD connect, then use the...

Read More
Outlook Web App 2013 – Offline Mode
Nov17

Outlook Web App 2013 – Offline Mode

  KB ID 0000727  Problem A great new feature of OWA 2013 is the ability to run in ‘Offline mode’. This runs in the same manner as Microsoft Outlook’s ‘Cached Mode’ which has been built into full Outlook since version 2003. There are a few caveats before you can get it to work; Requirements for OWA Offline Mode 1. A compatible browser (Internet Explorer 10, Chrome 18, or Safari 5.1). source 2. You...

Read More
Manually Configuring HP Wireless (MSM 720 controller) for Public and Private Wireless Networks
Nov17

Manually Configuring HP Wireless (MSM 720 controller) for Public and Private Wireless Networks

KB ID 0000833  Problem In the following procedure I’ll configure the following; HP 5412zl Switch. Cisco ASA 5510 Firewall. HP MSM720 Controller. HP MSM460 and MSM317 Access Points. If you are configuring an MSM765zl or MSM775zl use the following article first. HP MSM765zl and 775zl – Initial Setup and Routing Assumptions Private SSID will be on the normal corporate LAN (In this case 172.16.254.0/24). Public SSID will get...

Read More
Cisco ASA – Configuring for NTP
Nov17

Cisco ASA – Configuring for NTP

KB ID 0000608 Problem With NTP, there will be two things you want to do, 1) Allow a device behind the ASA to take its time from a public NTP server, and 2) Set the ASA to take its system time from a public NTP sever (for accurate date stanps on the logs, and for time critical things like Kerberos authentication.) Solution Allow internal host(s) to get system time though the firewall. 1. Connect to the ASA, go to “enable...

Read More