Cisco ASA – Reverse Route Injection with EIGRP
KB ID 0001137 Problem I’ve followed your Reverse Route Injection article and its not working? This email dropped in my mailbox a while back As it turns out the article I had written was for OSPF, and this chap was using EIGRP. So I ran it up with EIGRP as well to test. Heres my topology, I want to inject the route for the remote site, into my internal EIGRP routing table. Solution Assuming EIGRP is already setup between the ASA...
Exchange – 4.5.1. 4.4.0 Primary Target 4.2.1 unable to connect to alternative host
KB ID 0000790 Problem My colleague Allen was doing an Exchange 2003 to 2010 migration today, and things were not going well, mail refused to flow from the Exchange 2003 server to the Exchange 2010 server (it flowed from 2010 to 2003 without error). During migrations that’s not unusual, and removing and recreating the routing groups usually fixes it, but he had done that. Mail was sat on the Exchange 2003 Server outbound queues on the...
Juniper SRX – ‘The Routing Subsystem Is Not Running’
KB ID 0001045 Problem While trying to deploy Solarwinds to monitor a Juniper SRX failover cluster, we were having no joy connecting to the management interface of the secondary/standby firewall. The management (fxp0) interface on the primary (node0) firewall we could get to OK. ] After jumping on the secondary firewall (via the console connection) we observed the following; error: the routing subsystem is not running Solution As you...
Manually Configuring HP Wireless (MSM 720 controller) for Public and Private Wireless Networks
KB ID 0000833 Problem In the following procedure I’ll configure the following; HP 5412zl Switch. Cisco ASA 5510 Firewall. HP MSM720 Controller. HP MSM460 and MSM317 Access Points. If you are configuring an MSM765zl or MSM775zl use the following article first. HP MSM765zl and 775zl – Initial Setup and Routing Assumptions Private SSID will be on the normal corporate LAN (In this case 172.16.254.0/24). Public SSID will get...
HP MSM765zl and 775zl – Initial Setup and Routing
KB ID 0000917 Problem The MSM 765zl and 775zl, unlike the rest of the HP MSM controller series, do not have any physical Ethernet ports on them. So before you can get to its web management interface, you need to be able to give it an IP address, and then the controller needs to be able to find a route back to where you are, assuming you are not on a flat unrouted/single VLAN. Obviously if you are directly connected to the same...