VMware Error – Host {name} currently has no management network redundancy
Nov17

VMware Error – Host {name} currently has no management network redundancy

KB ID 0000231  Problem Seen in Vmware ESX / Vmware Vsphere environments with both ESX and ESXi hosts. Solution As far as errors go this one’s pretty straight forward (and very common). I’ve seen it in ESX3 and VSphere networks, with high availability clusters. It’s complaining because there is only one physical NIC presented to the Service Console (I know ESXi does not have a service console, but it has a management...

Read More
Exchange 2007 – Install the x32 Bit Management Tools
Nov17

Exchange 2007 – Install the x32 Bit Management Tools

KB ID 0000285  Problem As you may already be aware Exchange 2007 on a x32 bit machine is NOT supported in a production environment, however there is one exception, x32 bit Exchange 2007 IS supported for management only. Note: There is NO x32 bit support, (or media) for Exchange 2010 (and newer). Solution You can install these tools on XP, 2003, Vista or Windows 7. For this Example I’ll use XP Pre-Requisites 1. Install IIS: Start...

Read More
HP MSM765zl and 775zl – Initial Setup and Routing
Nov17

HP MSM765zl and 775zl – Initial Setup and Routing

KB ID 0000917  Problem The MSM 765zl and 775zl, unlike the rest of the HP MSM controller series, do not have any physical Ethernet ports on them. So before you can get to its web management interface, you need to be able to give it an IP address, and then the controller needs to be able to find a route back to where you are, assuming you are not on a flat unrouted/single VLAN. Obviously if you are directly connected to the same...

Read More
Cisco Catalyst Switches – Set a Management IP and Allow Telnet and Web Management
Nov17

Cisco Catalyst Switches – Set a Management IP and Allow Telnet and Web Management

KB ID 0000614  Problem If you want to manage your Cisco Catalyst switch it’s not always practical to plug a console cable in to change its settings or monitor what it is doing. Putting an IP address on it and enabling remote management via Telnet or from your web browser is a better alternative, particularly if you have a lot of switches. Solution Enable Telnet Management on Cisco Catalyst Switch 1. Connect to the Switch using a...

Read More
Manage your Cisco Firewall from your Windows Mobile Device
Nov17

Manage your Cisco Firewall from your Windows Mobile Device

KB ID 0000158  Problem You have a new windows mobile device and your bored! – well not really, I hope I never have to do this in anger but, It was an exercise in proving it can be done 🙂 Solution Before you start you need to ensure the following has been done, 1. The firewall in question needs an RSA Key generating on it, (on the firewall issue the following command “crypto key generate rsa” {without the quotes}. 2....

Read More