Event ID 434
Nov17

Event ID 434

KB ID 0000350 Problem Event ID 434 Source: CPQTeamMP Description HP Network Team #1: PROBLEM: A non-Primary Network Link is not receiving. Receive-path validation has been enabled for this Team by selecting the Enable receive-path validation Heartbeat Setting. ACTION: Please check your cabling to the link partner. Check the switch port status, including verifying that the switch port is not configured as a Switch-assist Channel....

Read More
HP and Cisco – VLANs and Trunks Confusion!
Nov17

HP and Cisco – VLANs and Trunks Confusion!

KB ID 0000741 Problem When I first started in IT, I went and did my Cisco CCNA. So I learned that to connect Cisco switches and pass VLAN traffic between them, I needed to create a ‘Trunk’ to pass the VLAN traffic. Fast forward a few years, and I now work for an HP reseller. Very early on I came to realise that what HP called a ‘trunk’ was very different from what I had been taught. Below is an article I did a...

Read More
Cisco IOS – Configuring Switch to Switch MACSEC
Nov17

Cisco IOS – Configuring Switch to Switch MACSEC

KB ID 0001000  Problem My colleague had to set this up on the test bench today, and it looked infinitely more interesting that what I was doing, so I grabbed my console cable, and offered to ‘help’. This was done on two Cisco Catalyst 3560-X switches, each with a 10G Service Module (C3KX-SM-10G), and 1Gb SFP modules (Note: Not 10Gb ones, this will become important later). Solution 1. First hurdle was, when we tried to add...

Read More
Cisco Catalyst – Upgrading ‘Stacked’ Switches
Nov17

Cisco Catalyst – Upgrading ‘Stacked’ Switches

KB ID 0001002 Problem The following procedure was carried out on two Cisco Catalyst 3750 switches. Solution 1. We can see (above) that we have two switches, but if your connected remotely, best make sure. Petes-Stack#show switch Switch/Stack Mac Address : 0018.7347.a000 H/W Current Switch# Role Mac Address Priority Version State...

Read More
Cisco Catalyst – ‘Daughtercard inserted in this switch may not have been manufactured by Cisco’
Nov17

Cisco Catalyst – ‘Daughtercard inserted in this switch may not have been manufactured by Cisco’

KB ID 0001018  Problem In a newly deployed switch, the MACSEC link refused to establish, when I consoled in I was greeted with this; Dec 06 01:30:07.023: %ILET-1-DEVICE_AUTHENTICATION_FAIL: The FRULink SM Daughtercard inserted in this switch may not have been manufactured by Cisco or with Cisco’s authorization. If your use of this product is the cause of a support issue, Cisco may deny operation of the product, support under...

Read More