VMware: Fiber Channel HBA Reports Wrong WWN?
KB ID 0001534 Problem I was building some new ESX 6.7 U1 (HPE) servers this week, they had Emulex Fiber HBA’s in them. When it came to ‘allowing’ them access to the SAN, I went to get the Port World Wide Name; And was presented with this; Not only is that 19 Characters long, and not 16 characters, but BOTH VMHBA’s WERE THE SAME! Like MAC addresses they should be unique? So I’m guessing this is a bug....
Cisco IOS: Ether-Channel Trunks
KB ID 0001533 Problem This is a subject that every time I need to create an Ether-Channel I end up checking beforehand, so it’s about time I wrote it up. We are combining two different things, an Ether-channel, (an aggregation of links) and a Trunk (the ability to carry many VLANS). If you are NOT from a Cisco background then you might want to read though the following post first to avoid confusion about the world...
VMware: Change IOPS Limit From 1000 to 1
KB ID 0001532 Problem I got asked to do this by a client this week, HP has requested that this be set for connections to their Storevirtual VSA that had been having some problems. Solution I followed the instructions and was at first confused because I could not see the settings that needed changing? That’s because this only applies if you have MULTIPATHING enabled and set to ‘Round Robin’. So if your storage does...
Cisco ASA VPN to Cisco Router “MM_WAIT_MSG3”
KB ID 0001531 Problem While migrating a VPN tunnel from an ASA 5520 firewall to a new 5516-X I got this problem. The other end was a Cisco router (2900). As soon as I swapped it over, it was stuck at MM_WAIT_MSG3, and phase 1 would not establish; NUFC-ASA5516x(config-tunnel-ipsec)# show crypto isa IKEv1 SAs: Active SA: 6 Rekey SA: 0 (A tunnel will report 1 Active and 1 Rekey SA during rekey) Total IKE SA: 6 1 IKE Peer: 1.1.1.1 Type :...
Cisco ASA: “Wrong Serial Number?”
KB ID 0001530 Problem Cisco have done this for a while, the first time I saw it was years ago on a 5585, but all the NGFW models now have a ‘Serial Number” and a “Chassis Serial Number”. Normally you don’t care unless you need to log a TAC call online. So you issue a show version command, take a note of the serial number, and then it says, there’s no record of that serial number? Solution Just to be...