How Do I Find/Change My IP Address?
KB ID 0000208 What’s an IP address? An IP address is the address used on a network to find your PC, Server, Laptop, or Printer etc. It’s the networking equivalent of your house number and post code (or Zip Code for visitors from over the pond). Do you want your PUBLIC or PRIVATE IP address? As we started to run out of addresses, there were a number of solutions that we came up with, one you will see below (DHCP) the other...
Cisco ASA Site To Site VPN IKEv1 “Using CLI”
Do the same from ASDM KB ID 0000050 Problem Note: This is for Cisco ASA 5500, 5500-x, and Cisco Firepower devices running ASA Code. Note: This is quite an OLD POST, only use these instructions if you need to create a VPN tunnel that uses IKEv1, (i.e. The other end is not a Cisco ASA, or it’s a Cisco ASA running code older than 8.4). You can still use an IKEv1 tunnel of course, so this article is still valid, it’s just...
Cisco ASA Site to Site VPN ‘Using ASDM’
KB ID 0000072 Problem Note: This is for Cisco ASA 5500, 5500-x, and Cisco Firepower devices running ASA Code. Do the same from command line Below is a walk-through for setting up one end of a site to site VPN Tunnel using a Cisco ASA appliance – Via the ASDM console. Though if (like me) you prefer using the Command Line Interface I’ve put the commands at the end. click image for full subnet information Solution VPN Setup...
Cisco ASA Static (One to One) NAT Translation
KB ID 0000691 Problem Note: This is for Cisco ASA 5500, 5500-x, and Cisco Firepower devices running ASA Code. If you have a spare/available public IP address you can statically map that IP address to one of your network hosts, (i.e. for a mail server, or a web server, that needs public access). This is commonly referred to as a ‘Static NAT’, or a ‘One to One translation’. Where all traffic destined for public...
Cisco ASA AnyConnect VPN ‘Using ASDM’
KB ID 0000069 Problem Note: This is for Cisco ASA 5500, 5500-x, and Cisco Firepower devices running ASA Code. Below is a walk through for setting up a client to gateway VPN Tunnel using a Cisco Firepower ASA appliance. This was done via the ASDM console. The video was shot with ASA version 9.13(1) and ASDM 7.13(1). Suggestion: If you are setting this up for the first time, I would suggest setting it up to use the ASA’s LOCAL...