Cisco AnyConnect – Running ‘Logon Scripts / OnConnection Scripts’
KB ID 0001353 Problem I’ve seen this asked a lot in forums, and it came up on EE again today. I’ve never had to set this up in the past, but I’ve posted the links to the correct Cisco articles when people have asked. After the question was asked again today, I thought I’d take the time to write a decent article on how to do it. Why would you want to do this? You might want to map/reconnect a mapped drive, or...
Cisco ASA: ‘ERROR: Multiple Peers can be specified only with originate-only connections’
KB ID 0001316 Problem This week I had a client who had a head office and three satellite sites. They had old firewalls (a 5510 and 5505’s), and my firm had installed FTTC circuits, into the sites for them. My job was to reconfigure the firewalls and the site to site VPN tunnels (each site had a tunnel to the other sites), then disconnect their old ADSL connections, change the firewalls public IP, then connect to the shiny new...
Meraki To Cisco ASA 5500 Site to Site VPN
KB ID 0001255 Problem This was surprisingly easier than I was expecting! Special thanks to Steve for letting me loose on his test network for the Meraki end of the tunnel. Here I’m using an MX 64 Security appliance, and a Cisco ASA 5510. Note: The Meraki device will need a static IP. Solution Configuring Meraki MX Device for VPN to a Cisco ASA From your Meraki dashboard > Security Appliance > Site To Site VPN. If you...
Cisco ASA – Adding New Networks to Existing VPNs
KB ID 0001240 Problem Note: To add new subnets to an AnyConnect Remote Access VPN, see the following article instead; Cisco ASA – Adding New Networks to AnyConnect VPNs I see this get asked in forums A LOT, so I though I’d get around to getting it written up. If you have an existing VPN to a remote site and then need to add another network how do you do it? Well that depends on where the new network is, and how it’s...
Cisco VPN Client Connects but no traffic will Pass
Note: May also be asked as, Client VPN connects but cannot ping anything behind the Firewall. KB ID 0000199 Problem If I had a pound for every time I’ve seen this either in the wild, or asked in a forum, I would be minted! In nearly every case the problem is NAT related. In most cases, If the person launching the VPN client is behind a device that is performing NAT, (Home Router, Access Point, Firewall, etc) then the device will...