Error 1722 There is a problem with this Windows Installer package.
Error 1722 KB ID 0000985 Problem Error 1722 is a pretty ‘generic’ windows installer package error. When attempting to install the AnyConnect client software this happened; Error 1722. There is a problem with this Windows Installer package. A program run as part of the setup did not finish as expected. Contact your support personnel or package vendor. Action VACon_Install, location: C:Program FilesCiscoCisco AnyConnect...
Cisco VPN Client Connects but no traffic will Pass
Note: May also be asked as, Client VPN connects but cannot ping anything behind the Firewall. KB ID 0000199 Problem If I had a pound for every time I’ve seen this either in the wild, or asked in a forum, I would be minted! In nearly every case the problem is NAT related. In most cases, If the person launching the VPN client is behind a device that is performing NAT, (Home Router, Access Point, Firewall, etc) then the device will...
Windows and Cisco (IPSEC) VPN Client
KB ID 0000693 Problem I’d been running Windows 8 for a while now. But was the first time I needed to use my Cisco VPN Client software. So I was not happy when this happened. Note: Using VPN Client version 5.0.07.0440 Secure VPN Connection terminated locally by the Client. Reason 442: Failed to enable Virtual Adapter. Solution As it turns out this is a known problem with Windows 8, and there is a work-around. 1. Press Windows...
Cisco – Windows x64 Bit VPN Client (IPSEC)
Note: This page was originally written before the release of the Cisco x64 bit Windows 7 Client KB ID 0000163 Problem I was widely accepted for some time that Cisco’s support for the IPSEC VPN client will not be extended to x64 bit Windows platforms, That’s simply because they are gearing up towards their own AnyConnect VPN client. Update 18/02/10 – Cisco have released an x64 Bit VPN Client for Windows 7...
Cisco ASA 5500 Client VPN Access Via Kerberos (From CLI)
KB ID 0000049 Problem You would like to enable remote access for your clients using the Cisco VPN Client software. Solution Before you start – you need to ask yourself “Do I already have any IPSEC VPN’s configured on this firewall?” Because if its not already been done, you need to enable ISAKMP on the outside interface. To accertain whether yours is on, or off, issue a “show run crypto isakmp”...