Cisco Firepower Services – Change IP and DNS Addresses
KB ID 0001173 Problem If you change your internal LAN addresses its easy to re-ip the firewall but what about the FirePOWER module? If you manage your SFR from the ASDM it will tell you what the IP is, but it won’t let you change it? Solution Change the FirePOWER Module IP Address Log into the firewall, then open a session with the SFR module. find the physical address of the module (usually eth0, but check). Petes-ASA#...
Cisco FirePOWER – Adding a Static Route
KB ID 0001172 Problem Routing traffic back from the ASA , in most cases you will have a static route (or routes) tied to the inside interface of the firewall. Or you may have dynamic routing if your network is a little more complex. But your FirePOWER module is essentially a small Linux box sat inside the firewall, it has its own network connection and maintains its own routing table. You may have already noticed if your FirePOWER...
Migrate Exchange 2010 to Exchange 2016 or 2013
Part 2 Migrate Public Folders Exchange 2010 to Exchange 2013 / 2016 KB ID 0000789 Problem Continued from Migration From Exchange 2010 to Exchange 2016 / 2013 Part 1 Solution Exchange 2016 / 2013 Migration Step 7 “Migrate Public Folders” Note: This article uses the newer ‘Batch Migration’ method. Make sure your exchange server is patched and up to date or the process will not work. Minimum Patch Levels Source:...
Microsoft Exchange Server Build Numbers
KB ID 0000344 Problem To find out what service pack and rollups have been applied to Microsoft Exchange you need to locate its “Build Number”. 2000/2003 2007 2010 Warning: After SP3 the build number does not update. To find your build number in Exchange 2010 (after SP3,) use the following command; exsetup | %{$_Fileversioninfo} 2019, 2016, and 2013 Find Exchange 2019 / 2016 and 2013 Build numbers from EMC (PowerShell) Run...