VMware Composer Install Fails

KB ID 0001498

Problem

While attempting to deploy VMware Composer, (in my case version 7) on a windows Server, (in my case 2016 Datacenter). This happened;

Composer Instllation Failed

Installation Failed

The wizard was interrupted before VMware Horizon7 Composer could be completely installed.

Your system has not been modified. To complete installation at another time please run setup again.

Click Finish to exit the wizard.

Annoyingly I know what it was straight away, because I’d read up on the subject before I started. 

Solution

‘Power Off’ the server, locate its VM > Edit Settings > VM Options > Boot Options > Ensure firmware is set to “EFI (recommended) > Note: It should be by default > Under Secure boot ‘Untick‘ Secure boot (EFI boot only) > OK.

Composer Server Disable Secure Boot

Power the server back on, then retry the VMware Horizon Composer installation.

Composer Server Installed

Related Articles, References, Credits, or External Links

NA

Author: PeteLong

Share This Post On

12 Comments

  1. After 6 hard hours finally I found your article
    Thank you a lot

    Post a Reply
    • No Worries, glad to help. 🙂

      Post a Reply
  2. A nauseating problem was finally solved.Thank you.

    Post a Reply
  3. You are the BEST….solved my issue

    Post a Reply
  4. With 7.11 it works. Thanks a lot

    Post a Reply
  5. Can secureboot be re-enabled after the install?

    Post a Reply

Leave a Reply to casey Cancel reply

Your email address will not be published. Required fields are marked *